ISO 101 ( REV. D ) Series EMI/RFI circular connector backshells are lightweight, economical, and saves space by eliminating the rotating coupling nut.  The slot and boot groove are optional providing faster lead times and lower cost. Military MIL-spec. Some connector interfaces include, but are not limited to: MIL-C-5015, 26482, D38999 Series I, II, III, IV.

SO 160 SERIES ( REV. K ) EMI/RFI circular connector backshells offer two banding surfaces for double gross over braid requirements. It is available in straight, 45 and 90-degree angular functions.  They interface with MIL 26482, D38999 Series I,II,III,IV and more.

ISO 191 SERIES ( REV. J ) EMI/RFI circular connector backshells are our hinged low profile back shell with an elliptical cable entry, allowing for easy repair/service in the field with direct access to pin contacts and wires. Military MIL spec. They interface with MIL 26482, D38999 Series I,II,III,IV and more. Available in 90-degree cable entry only. E.W.I.S. Solutions.

ISO 215 SERIES ( REV. P ) EMI/RFI D-sub connector backshells are an elliptical Micro D-subminiature. Interfaces with MIL 83513 connectors, available in straight and 45 degree angular entry only. Military MIL spec. Standard 9,15,21,25,31,37,51, and 100 pin layouts.

ISO 135 SERIES ( REV. Q ) EMI/RFI circular connector backshells are a miniaturized backshell solution that interfaces with Glenair 800, 801, 803, 804 & 805 Mighty Mouse, and Filconn Field Mouse connectors. Military MIL spec.

SO 170 SERIES ( REV. E ) The 170 series is a low profile, two-piece design with a single banding platform. The two-piece design allows for easier repair service in the field while the low profile offers additional space savings over our standard back shells. They interface with MIL 26482, D38999 Series I,II,III,IV and more.

Isodyne’s RJ45 backshell provides EMI shielding and protection for COTS RJ45 connectors both shielded and non-shielded. Set screws on each side of the backshell are used to hold the connector in place and provide a grounding path to the connector shield.

ISO 750 SERIES ( REV. G ) Bulk head connector backshells can often replace a connector used as a junction point saving weight and cost. Military MIL spec.

ISO 150 SERIES ( REV. AF ) EMI/RFI circular connector backshells offer a single banding surface and are available in straight, 45 and 90-degree angular functions and interfaces with MIL 26482, D38999 Series I,II,III,IV and more. Military MIL spec.

ISO 180 SERIES ( REV. K ) EMI/RFI circular connector backshells are a low profile hinged solution that allows easy access to the pins for field repair service with direct access to pins and contacts. Particularly beneficial when using high pin count connectors to allow ease of routing wires in the back shell. Military MIL spec. They are compatible with MIL 26482, D38999 Series I,II,III,IV and more. Available in Straight, 45, & 90-degree E.W.I.S. Solutions.

ISO 205 SERIES ( REV. AB ) EMI/RFI D-sub connector backshells are a D-subminiature that interface with MIL 24308 series connectors standard pin layouts. Military MIL spec. Available in straight, 45 and 90 degree cable entry.

ISO SPLICKIT-T SERIES ( REV. G ) Comes in T, X and straight configurations custom lengths and custom entry cable diameters to meet your specific needs.